OpenBCM V1.07b12 (Linux)

Packet Radio Mailbox

DB0FFL

[Box DB0FFL]

 Login: GAST





  
I0OJJ  > SPACE    02.01.22 11:25l 56 Lines 2763 Bytes #999 (0) @ WW
BID : 52383I0OJJ
Read: GAST
Subj: [AMSAT-UK] FUNcube - Welcome to 2022
Path: DB0FFL<OE2XZR<OE6XPE<IW2OHX<UA6ADV<LU4ECL<I0OJJ
Sent: 220102/0901z @:I0OJJ.ITA.EU [Rome] $:52383I0OJJ

AMSAT-UK

///////////////////////////////////////////
FUNcube - Welcome to 2022

Posted: 01 Jan 2022 06:22 AM PST
https://amsat-uk.org/2022/01/01/funcube-welcome-to-2022/

FUNcube-1  Battery Voltage  Whole Orbit Data

There are presently three FUNcube based missions in orbit – currently all  
of them have active, linear U/V transponders. The current status of each of  
these can always be checked on the useful AMSAT-NA status page  
https://www.amsat.org/status/ and an update on each of them is provided  
below. Please have FUN using them!

AO73 – FUNcube1. As previously reported AO73 appears to be experiencing  
some power issues after 8+years in orbit.

The battery is not charging to the same voltage as it did up to early  
November last year. The spacecraft has experienced many months of  
continuous sunlight over the past couple of years and this has resulted in  
high (around +30C) onboard temperatures. This environment may have “cooked”
 the cells although presently we do not see any direct evidence of this.

We can see that the stable bus voltage indicated at the end of charge is  
now much lower and depends on the current being taken by the on-board  
systems. The solar panel currents appear to be similar to those recorded  
soon after launch. The current best theory is that we are seeing the effect  
of some increased resistance in the supply circuit between the eps charging  
circuit and the battery. Although we do not have access to a fully detailed  
circuit diagram of the EPS we believe that there is an “ideal diode” in  
this line to prevent discharge of the battery back through the EPS  
circuitry. We understand that this is actually a MOSFET device and the  
suspicion is that this may now be showing signs of radiation damage.

So an operational mode has been selected that can be hopefully sustained  
for some time. From today AO73 is in continuous transponder mode and is  
available for use 24/7. Low power telemetry is also being transmitted and  
reports of the data are very welcome via the FUNcube Data Warehouse. Please  
remember that the uplink frequency varies with on board temperatures. A  
lower temperature means a higher frequency!

EO88 – Nayif-1. EO88 continues to perform nominally and is switching  
between high power telemetry for educational outreach when in sunlight and  
to its U/V transponder mode when in eclipse. It will soon celebrate its 5th  
birthday in space after launch on 15th February 2017.

JO97 – JY1Sat. JO97 suddenly stopped transmitting telemetry data on May 1st  
last year. The cause of this anomaly is unknown but fortunately the U/V  
transponder continues to operate continuously.
Battery voltage and incoming solar current over time  daily average





Lese vorherige Mail | Lese naechste Mail


 26.11.2024 21:16:27lZurueck Nach oben